Brother P-touch PT-2700 Guide De L'utilisateur page 76

TROUBLESHOOTING
Problem
The label is not cut
automatically.
Label files saved
previously are now
empty.
74
What to do when...
Cause
Is Cut Option set to Chain or
No Cut?
Is Manual Cutting set to ON? When using Fabric Iron-On
Have the batteries and AC
adapter been disconnected?
Is there enough power
remaining in the batteries?
Have you used the Reset
function?
Solution
When these options are set,
the tape is not fed after
printing the label. Check the
Cut Option setting, or hold
down the key and press
the key to feed and
cut the tape.
Tapes or Extra Strength
Adhesive Tapes, please use
scissors to cut the tape after
printing.
When using other tapes,
refer to "Manual Cutting" on
page 64 and set the Manual
Cutting to OFF to cut the
tape automatically.
All files stored in the internal
memory is lost if the
batteries and AC adapter are
disconnected for longer than
one minute.
All data stored in the internal
memory is lost if the
batteries become empty.
The reset function clears all
data stored in the internal
memory, including label
files.