Publicité
Les langues disponibles
Les langues disponibles
Risk of severe injuries
For safety reasons, always use the
¾
safety guard when working with
cutting wheels.
Two-hole nut
Tightening the two-hole nut (Fig. III)
Attention!
The two sides of the two-hole nut [7] are different.
Screw the two-hole nut [7] onto the spindle as
follows:
With thin grinding wheels
• The collar of the two-hole nut [7] faces upwards
so that the thin grinding wheel can be securely
clamped.
With thick grinding wheels
• The collar of the two-hole nut [7] faces down-
wards so that the two-hole nut can be securely
screwed onto the spindle.
▸
Lock the spindle.
▸
Tighten the two-hole nut in clockwise direction
using the two-hole wrench [6].
Loosening the two-hole nut
▸
Lock the spindle.
▸
Unscrew the two-hole nut [7] in an anti-clockwise
direction using the two-hole wrench [6].
Quick-clamping nut
Tightening the quick-clamping nut
Attention!
Use the quick-clamping nut [8] only on machines
with the "quick-clamping system".
Attention!
If the abrasive wheel [9] is thicker than 6 mm in
the clamping area, the quick-clamping nut must not
be used!
Use the two-hole nut [7] with the two-hole
¾
wrench [6].
▸
Lock the spindle.
▸
Fold up the clip of the quick-clamping nut [8].
22
CAUTION!
▸
Place the quick-clamping nut [8] onto the spindle [12].
▸
Tighten the clip of the quick-clamping nut [8] ma-
nually in the clockwise direction and fold down.
Loosening the quick-clamping nut
▸
Lock the spindle.
▸
Fold up the clip of the quick-clamping nut [8].
▸
Manually unscrew the quick-clamping nut [8] in
an anti-clockwise direction.
If the quick-clamping nut is too tight, it can be
loosened using the two-hole wrench [6].
Operation
Switching ON/OFF
WARNING !
Risk of severe injuries.
Always guide the machine with both
¾
hands.
First switch on, then bring the
¾
attachment into contact with the
workpiece.
WARNING !
Danger of unintentional starting
Always switch off the machine when
¾
the mains plug is removed from the
plug socket or if a power failure has
occurred.
Risk of a dust explosion.
Take care to prevent the machine
¾
from drawing in additional dust and
chips.
Keep away from dust deposits when
¾
switching the machine ON and OFF.
WARNING !
Risk of severe injuries.
If the machine is set to continuous run-
Â
ning, it will continue to run if it is torn
out of your hand.
Always hold the machine with both
¾
hands at the handles provided, take
up a stable posture and concentrate
on the work in hand.
DANGER!
Publicité
