Würth FKWS 9-125 Traduction Des Instructions De Service D'origine page 18

Avoid the area in front of and behind
b)
the rotating cut-off wheel. If you move the
cut-off wheel away from yourself in the work-
piece, the electric tool with the rotating wheel
can suddenly fly towards you in the event of a
recoil.
If the cut-off wheel jams or you inter-
c)
rupt the work, switch off the device and
hold it steady until the wheel has come
to a standstill. Never try to pull the running
cut-off wheel out of the cut as this could result in
a recoil. Identify and remedy the cause of the
jamming.
Do not switch on the electric tool again
d)
as long as it is in the workpiece. Allow
the cut-off wheel to reach its full speed before
carefully continuing the cut. Otherwise the wheel
may snag, spring out of the workpiece or cause
a recoil.
Support plates or large workpieces to
e)
reduce the risk of a recoil caused by the
cut-off wheel jamming. Large workpieces
can bend under their own weight. The workpiece
must be supported on both sides of the wheel,
both in the vicinity of the cut and at the edge.
Be particularly careful when cutting
f)
"pockets" in existing walls or other sur-
faces that you cannot see behind. As the
wheel cuts into the surface it may collide with gas
or water pipes, electric cables or other objects
and cause a recoil.
18
Special safety instructions
Special safety precautions during
sanding:
a)
follow the manufacturer's specifications
for the sanding disc size. Sanding discs
that extend beyond the grinding disc can cause
injuries and lead to blocking and breakage of
the sanding disc or result in a recoil.
Special safety precautions when
working with wire brushes:
a)
wire even during normal operation. Do
not overload the wires by applying too much
contact pressure. Flying pieces of wire can very
easily penetrate through thin clothing and/or the
skin.
b)
care that the wire brush does not come
into contact with the safety hood. Disc
and cup brushes may increase their diameter due
to the contact pressure and centrifugal force.
Do not use oversized sanding discs and
Note that wire brushes lose pieces of
If a safety hood is recommended, take