Publicité
Les langues disponibles
Les langues disponibles
Intended use
This device is only to be used as a grinder, sander,
for work with wire brushes and for cut-off machi-
ning of metal, concrete, stone and similar materials
without the use of water. Use only original Würth
accessories. Any other use or use outside this scope
is considered improper use.
The user alone is responsible for damage
resulting from improper use.
Technical Data
Art.
Rated power consumption
Power output
No-load speed
Grinding wheel dia., max.
Spindle thread
Length of grinding spindle
Min. attainable angle
Speed at the rated load
Maximum torque
Rubbing disc / cut-off wheel:
Max. permissible thickness of the
attachment
Max. permissible thickness of the
attachment in the clamping area
when using:
a) Two-hole nut [7]
b) Quick clamping nut [8]
Weight without mains lead
Protection class
Symbols on the name plate:
n = max. no-load speed
∼ = Alternating current
20
Noise emission values
These values enable the estimating of the noise
emissions of the power tool and comparison with
5707 000 X
various power tools. Dependent on the conditions
W
910
of use, state of the power tool or attachments, the
actual loading may be greater or smaller. When
W
430
estimating also take into consideration work breaks
rpm 10,000
and phases with lower loading. Specify protective or
organisational measures for the user based on the
mm
125
corresponding adjusted estimation values.
M14
Art.
mm
18
a
h, SG
43°
a
h, DS
rpm
8,200
L
/K
pA
Nm
2
L
/K
WA
mm
6
Vibration total value (vector sum in three directions)
measured in accordance with EN 60745:
a
a
K
Typical A-rated sound pressure level:
mm
6
L
mm
8
L
kg
2.1
K
/II
* The specified vibration emission values:
• Were measured using a standardised test method
and can be used to compare one electric tool
with another.
• Can be used for a rough assessment of the
exposure.
Noise /vibration information
WARNING !
The noise level may exceed 80 dB(A)
during work.
Risk of severe injuries and acoustic
Â
trauma.
Wear ear protectors!
¾
/K
*
m/s
h, SG
/K
*
m/s
h, DS
dB (A)
pA
dB (A)
WA
,
= Vibration emission value (surface grinding)
h
SG
,
= Vibration emission value (grinding with grinding disc)
h
DS
= Uncertainty (vibration)
h, SG/DS
= Sound pressure level
pA
= Sound power level
WA
,K
= Uncertainty
pA
WA
5707 000 X
5.5/1.5
2
< 2.5
2
88/3
99/3
Publicité
