Publicité
Les langues disponibles
Les langues disponibles
INSTALLATIoN
Commissioning
12.4 Remote control
12.4.1 FE 7 remote control
With the FE 7 remote control you can adjust the set room tempera-
ture for heating circuit 1 or heating circuit 2 by ± 5 °C in automatic
mode only. You can also select the operating mode. Connect the
remote control to Fernb.1, Fernb.3 and Fernb.- at terminal X2.2
of the appliance.
12.4.2 FEK remote control
With the FEK remote control you can select the operating mode
and change the set room temperature for heating circuit 1 or
heating circuit 2 by ± 5 °C. Connect the remote control to H, L
and + of terminal X5 of the appliance.
www.stiebel-eltron.com
319204_HSBC_200_de_en_fr_nl_it.indb 45
1 2 3 4 5 6
H L
+
13. Commissioning
Our customer support can assist with commissioning, which is a
chargeable service.
If the appliance is intended for commercial use, observe the rules
of the relevant Health & Safety at Work Act during commissioning.
For further details, check with your local authorising body (in
Germany, for example, this is the TÜV).
13.1 Checks before commissioning the heat pump
manager
Material losses
!
Observe the maximum system temperature in underfloor
heating systems.
f Check that the heating system is filled to the correct pressure
f
and the quick-action air vent valve is closed.
f Check whether the outside temperature sensor is correctly
f
placed and connected.
f Check whether the power supply is connected correctly.
f
f Check whether the signal cable to the heat pump (bus cable)
f
is correctly connected.
High limit safety cut-out
Note
At temperatures below –15 °C the high limit safety cut-out
may respond. The appliance may be subjected to these
temperatures during storage or transport.
f Check whether the high limit safety cut-out has tripped.
f
1 High limit safety cut-out reset button
1
HSBC |
45
17.10.2017 10:35:46
Publicité
