Télécharger Imprimer la page

Stiebel Eltron HSBC 200 Utilisation Et Installation page 34

Publicité

Les langues disponibles
  • FR

Les langues disponibles

INSTALLATIoN
Safety
INSTALLATIoN
8.
Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
8.1
General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
8.2
Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
9.
Appliance description
9.1
Standard delivery
The following are delivered with the appliance:
- Operating and installation instructions for the WPM 3 heat
pump manager
- Outside temperature sensor AFS 2
- 4 adjustable feet
- Drain hose
9.2
Accessories
Required accessories
Safety assemblies and pressure reducing valves are available
to suit the prevailing supply pressure. These type-tested safety
assemblies protect the appliance against impermissible excess
pressure.
Required for area cooling:
- Temperature sensor TF 6
- FEK remote control
Additional accessories
- Pump assembly for a heating circuit with mixer HSBC-HKM
- Remote control for heating operation
- High limit safety cut-out STB-FB
- Pressure hoses
- Water softening fitting HZEA
34
| HSBC
319204_HSBC_200_de_en_fr_nl_it.indb 34
10. Preparations
10.1 Installation site
Material losses
!
Never install the appliance in wet rooms.
Install the appliance near the draw-off point in a dry room free
from the risk of frost. To reduce line losses, keep the distance short
between the appliance and the heat pump.
Ensure the floor has sufficient load-bearing capacity and evenness
(for weight, see chapter "Specification / Data table").
The room must not be subject to a risk of explosions arising from
dust, gases or vapours.
If you are installing the appliance in a boiler room together with
other heating equipment, ensure that the operation of other heat-
ing equipment will not be impaired.
Minimum clearances
≥500
The minimum side clearances can be swapped between left and
right.
≥100
www.stiebel-eltron.com
17.10.2017 10:35:10

Publicité

loading

Ce manuel est également adapté pour:

Hsbc 200 s