Publicité
Les langues disponibles
Les langues disponibles
Dell Networking OS
To initially configure the Dell Networking operating system (OS), use the
following sections.
NOTE: This chapter applies ONLY if you already have the Dell
Networking OS installed on your system from the factory. If you are
installing a third-party OS, refer to your third-party OS documentation.
NOTE: For complete installation and configuration information, refer to
the following documents at www.dell.com/support:
•
Dell Networking Installation Guide for the S3048–Open Networking
(ON) System.
•
Dell Networking Command Line Reference Guide for the S3048–
Open Networking (ON) System.
•
Dell Networking Configuration Guide for the S3048–Open
Networking (ON) System.
•
Dell Networking Release Notes for the S3048–Open Networking
(ON) System.
Enter the Initial Configuration Information
To set up the switch, assign an IP address and other configuration information
necessary for the switch to communicate with the local routers and the
Internet. The minimal configuration provided here does not cover most of the
features; it simply allows you to perform other configuration tasks using a
Telnet connection from your management network.
NOTE: To configure other features and interfaces, refer to the Dell
Networking OS Configuration Guide for the S3048 System.
IP Settings
To set up the switch, get the following information from your network
administrator:
•
Switch IP address
•
Subnet mask (IP netmask)
•
Default gateway (router)
•
Enable secret password
•
Enable password
21
Publicité
