EINHELL TH-DY 500 E Instructions D'origine page 15

The scale (a) can serve as a rough guide if the
depth setting ring (2) should move or if several
screwing depths are needed in alternation.
5.2 Changing the tool insert
To change the tool insert, rotate the screwing
depth stop (1) with the depth setting ring (2) as far
as the maximum screwing depth and pull off the
tool insert to the front (use pincers if necessary).
5.3 Screwdriving work
It is advisable to use self-centering screws (e.g.
Torx, cross recessed head) as these will enable
you to work safely and reliably. Always make sure
that the tool insert used is of the same size and
shape as
6. Operation
6.1 ON/OFF switch (Item 4)
To switch on:
Press the ON/OFF switch (4)
Continuous operation:
Secure the ON/OFF switch (5) with the locking
button (4).
To switch off:
Press the ON/OFF switch (4) briefly.
6.2 Adjusting the speed (Item 4)
•
You can infinitely vary the speed whilst using
the tool.
•
Select the speed by applying a greater or les-
ser pressure to the ON/OFF switch (4).
•
Select the correct speed: The most suitable
speed depends on the workpiece, the type of
use and the drill bit used.
•
Low pressure on the ON/OFF switch (4): Lo-
wer speed (suitable for: small screws and soft
materials)
•
Greater pressure on the ON/OFF switch (4):
Higher speed (suitable for large/long screws
and hard materials)
6.3 Preselecting the speed (Item 3)
•
The speed setting ring (3) enables you to
define the maximum speed. The ON/OFF
switch (4) can only be pressed to the defined
maximum speed setting.
•
Set the speed using the setting ring (3) on the
ON/OFF switch (4).
Anl_TH_DY_500_E_SPK9.indb 15
GB
6.4 Clockwise/Counter-clockwise switch
(tem 6)
•
Change switch position only when the drill is
at a standstill!
•
Using the slide switch above the ON/OFF
switch you can select the direction of rotation
of the screwdriver.
Direction
Clockwise
Counter-clockwise
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
- 15 -
Switch position
Pushed in to the right
Pushed in to the left
16.03.2018 11:49:56