Sony VPL-FH36 Guide De Référence Rapide page 37

4
Insert the new lamp all the way in until
it is securely in place. Tighten the
three screws.
5
Close the rear panel and tighten the
three screws.
Note
Be sure to install the lamp and rear panel
securely as it was. If not, the projector
cannot be turned on.
6
Connect the AC power cord to a wall
outlet and turn on the projector.
7
Reset the lamp timer for
the next replacement time.
Select "Lamp Timer Reset" on the
Function menu then press the ENTER
key. When a message appears, select
"Yes" to reset the lamp timer.
Disposal of the used lamp
For the customers in
the U.S.A. and Canada
New lamp
mercury. Dispose
according to applicable
local, state/province and
federal laws.
For additional information,
grab
see www.sony.com/
mercury
Screws
notification of
Lamp contains
Replacing the Lamp
17
GB