EINHELL GE-EA 18/150 Li BL-Solo Instructions D'origine page 14

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
Explanation of the symbols used (see Fig. 8)
1. Danger! - Read the operating instructions to
reduce the risk of injury.
2. Caution! Wear ear-muff s. The impact of noi-
se can cause damage to hearing.
3. Caution! Wear safety goggles. Sparks ge-
nerated during working or splinters, chips and
dust emitted by the device can cause loss of
sight.
4. Wear suitable, tight-fi tting protective clothing
when working.
5. Long hair should always be held in a hair net
(or in a cap)!
6. Wear gloves to protect your hands.
7. Wear safety shoes to protect your feet.
8. Warning! An abrupt blockage can cause inju-
ries.
9. Avoid contact with live cables - risk of electric
shock!
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
Warning!
Read all the safety information, instructions,
illustrations and technical data provided on
or with this power tool. Failure to adhere to the
following instructions may result in electric shock,
fi re and/or serious injury.
Keep all the safety information and instruc-
tions in a safe place for future use.
Anl_GE_EA_18_150_Li_BL_SPK13.indb 14 Anl_GE_EA_18_150_Li_BL_SPK13.indb 14
GB
2. Layout and items supplied
2.1 Layout (Fig. 1)
1. On/Off switch
2. Swtich settings/direction of rotation
3. Safety lock-off
4. Mount
5a. Stirrer (not supplied with the product)
5b. Adapter (not supplied with the product)
6. Auger screw 120mm (not supplied with the
product)
7. Auger screw 150mm
8. Extension 1m (not supplied with the product)
9. Folding split pin
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Motor unit
•
Auger screw 150mm
•
Original operating instructions
•
Safety instructions
- 14 -
11.05.2021 08:58:17 11.05.2021 08:58:17