Esc - Connecting Program Card; Esc - Trouble Shooting - Carson Virus 4.1 4S Brushless Mode D'emploi

ESC - CONNECTING PROGRAM CARD

• Remove the fan cable
• Connect programming box with connection
External Programming:
Port for Connecting
Program Card
(No 500906143)

ESC - TROUBLE SHOOTING

Trouble
After power on, motor doesn't work
After power on, motor doesn't work, but
emits "beep-beep-, beep-beep-" alert
tones
(Every group of "beep-beep-" has a time
interval of 1 second)
After power on, red LED always lights, the
motor doesn't work
The motor runs in the opposite direction
when it is accelerated
The motor suddenly stops running
When accelerating quickly, the motor
stops or trembles
GB // 30
• After completing the programming, reconnect the fans !!!
Possible reason
The connections between battery pack and
ESC are not correct
Input voltage is abnormal, too high or too
low
Throttle signal is abnormal
The wire connections between ESC and the
motor are not correct
The throttle signal is lost
The ESC has entered the "Low voltage
protection mode" or "Over-heat protection
mode"
The battery has a bad discharge perfor-
mance
The "Start mode (Punch)" of the ESC is too
aggressive
Solution
Check the power connections Replace the
connectors
Überprüfen Sie die Einstellung für die
BatteCheck the adjustment of the voltage of
the battery pack
Plug the receiver wire into the throttle
channel of the receiver correctly
Swap any two wire connections between
the ESC and the motor
Check the transmitter and the receiver
Red LED flashing means "Low voltage pro-
tection". Please replace battery pack.
Green LED flashing means "Over-heat pro-
tection", please stop running to cool the ESC.
Use a better battery
Select a softer option for the "Start mode
(Punch)"