Esc - Basic Settings - Carson Virus 4.1 4S Brushless Mode D'emploi

ESC - BASIC SETTINGS

Throttle range setting (throttle range calibra-
tion)
In order to make the ESC fit the throttle range of your transmitter,
you must calibrate it for the following cases; otherwise the ESC
cannot work properly.
There need to be set 3 points. They are the end point of "forward",
the end point of "backward" and the neutral point. The following
pictures show how to set the throttle range with your transmitter.
Note 1
The "SET" key of ESC is at the power switch (see picture).
Press and hold
Hold the SET
key
Release the SET key as soon as the red LED flashes.
C) Set the 3 points according to the steps.
1. The neutral point
Move the throttle lever at the neutral point, and then click the SET
key. The green LED flashes 1 time.
2. The end point of forward direction
Move the throttle lever at the end point of forward direction, and
then click the SET key, the green LED flashes 2 times..
GB // 26
1) Begin to use a new ESC
2) Begin to use a new transmitter
3) Change the settings of neutral position of the throttle lever, the
ATV or EPA parameters, etc.
A) Switch off the ESC and turn on the transmitter.
B) Hold the "SETUP"-key of the ESC and then switch on the ESC.
Release the "SETUP" key as soon as the red LED begins to flash.
Note 2
If you don't release the "SET" key as soon as the red LED begins to
flash, the ESC will enter the program mode. In such case, please
switch off the ESC and re-calibrate the throttle range again as
described.
Switch on
ESC
3. The end point of backward direction
Move the throttle lever at the end point of backward direction, and
then click the SET key, the green LED flashes 3 times.
The throttle range is calibrated; the motor can be started after 3
seconds.