Esc - Features; Esc - Connection/Cabling - Carson Virus 4.1 4S Brushless Mode D'emploi

ESC - FEATURES

This speed controller can easily be set for simple operation. After
powering up, it automatically searches for the neutral point. At the
end of the automatic setup, the motor emits a do-re-mi sound to
indicate that the neutral point has been adopted.
• Operating modes: forwards and forwards/backwards

ESC - CONNECTION/CABLING

Connect the ESC, motor, receiver, battery and
servo according to the following diagram.
Positive (+) and negative (-) wires of the ESC are connected with the
battery pack.
A, B and C are connected with the motor wires. The control cable of
Receiver
Input TH channel
Switch
Blue wire "A"
Yellow wire "B"
Orange wire "C"
Black power wire (battery
negative)
Steering servo
SET
• Proportional brake function with 4 steps of maximum brake
force adjustment, 8 steps of drag brake force adjustment
• Various start modes (also called "punch") from "soft" to "aggres-
sive"
• Splash-proof and dustproof.
the ESC (wires in black, red and white colour) is connected with the
throttle channel of the receiver (usually CH2).
The A, B, C wires of the ESC can be connected with the motor wires
freely (without any order).
If the motor runs in the opposite direction, please swap any two
wire connections.
Red wire to the positive of the ESC
Brushless motor
Red power wire (battery
positive)
Battery
Black wire to the
negative of the ESC
25 // GB