Austro Flamm Stila Mode D'emploi page 9

english
Heating in-between seasons
If you heat the stove in between seasons, when the
outside temperatures are higher, the flue gases may
not be able to escape completely and this may lead to
disturbances in the chimney draught, especially if the
temperatures are rising suddenly. The stove has to
be charged with less wood then and the primary air
has to be increased so that the wood can burn down
faster (with visible flames) and thus the chimney
draught can stabilize.
3. THE MOST IMPORTANT SPARES—OVERVIEW
Gaskets
Description
Gasket flat 10x5 mm, L=2300 mm
Gasket 15x8 mm, L=2200 mm
Keramott
Description
Baffle plate Keramott
Wood retainer, Keramott
Bottom right, Keramott
Bottom left, Keramott
Bottom rear, Keramott
Side Keramott
Rear Keramott
Baffle plate Keramott
Other parts
Description
Door complete
Door handle
Door glass
Glass cleaner ½ litre
Stove lacquer
Accessories
You can obtain floor plates of glass or steel or care products from your certified dealer.
IMPORTANT:
Have defective parts replaced by your certified dealer. This will guarantee that your
stove functions properly and safely.
The fireplace must not be amended.
Maintenance
To clean the glass, please use a specialized product such as Thermohit glass cleaner. Lacquered
surfaces are to be cleaned only with a cloth (may be damp). Special cleaning agents should also be used
for stainless steel surfaces.
Cleaning
The stove, flue outlets and smoke pipes should be cleaned and inspected for deposits every year – if
necessary more often, e.g. after the cleaning of the chimney. The chimney also has to be cleaned
regularly by the chimneysweeper. Your chimneysweeper will inform you of the necessary inspection
intervals. An expert should inspect the stove annually.
7
Chimney fire
A chimney fire may occur, due to sooting and
deposits in the chimney, if wrong or humid fuel is
used. In case of a chimney fire close all air inlets on
the fireplace/chimney immediately and call the fire
brigade. Please have an expert inspect your chimney
for cracks and air-tightness after the burning out of
the chimney.
Nr.drawing Part number
9 718438
10 718571
Nr.drawing Part number
1 715880
2 719591
3 719593
4 719592
5 719594
6 719595
7 719596
8 719597
Nr.drawing Part number
11 719580
12 719570
13 719540
-- 640070
-- 650002
Keramott numbering = installation instructions
Stila