Solving Operational Problems - FULGOR SOVB Manuel D'utilisation Et D'entretien

Before calling for assistance or service, please check "Troubleshooting." It may save you the cost of a service call.
If you still need help, follow the instructions below. When calling, please know the purchase date and the complete
model and serial number of your appliance. This information will help us to better respond to your request.
Oven Problem
F03 or F04 Error appear in
the display window.
Other F__ Error appear in the
display window.
The oven display stay OFF
Cooling fan continues to
run after oven is turned off
Oven door is locked and
will not release, even after
cooling
Oven is not heating
Oven is not cooking evenly
Oven temperature is too hot
or too cold
Oven light is not working
properly
Oven light stays on
Cannot remove lens cover on
light
Oven will not Self-Clean
properly
Clock and timer are not
working properly
Excessive moisture
Porcelain chips
Service Data Record
For authorized service or parts information see paragraph "Fulgor Warranty ..".
The location of the serial tag on the product can be seen when the oven door is opened. It is located on the left side, centered
vertically just inside the oven cavity. See Page 7. Now is a good time to write this information in the space provided below.
Keep your invoice for warranty validation.
Model Number _____________Serial Number ______________________Date of Installation or Occupancy_______________

Solving Operational Problems

A problem with latch mechanism occurred. Remove power and turn it back on again after a few
seconds. The oven should run a latch auto–test. If condition persists, note the code number
and call an authorized servicer.
Remove power and turn it back on again after a few seconds. If condition persists, note the
code number and call an authorized servicer.
Turn off power at the main power supply (fuse or breaker box). Turn breaker back on. The oven
should reset itself and will be operable. If condition persists, call an authorized service center.
The fan turns off automatically when the electronic components have cooled sufficiently.
Turn the oven off at the circuit breaker and wait a few seconds. Turn breaker back on.
The oven should reset itself and will be operable.
Check the circuit breaker or fuse box to your house. Make sure there is proper electrical power
to the oven. Make sure the oven temperature has been selected.
Check oven calibration. Adjust calibration if necessary (see To Set Temperature, Page 13).
Refer to cook charts for recommended rack position. Always reduce recipe temperature by
25°F (15°C) when baking with Convention Bake mode.
The oven thermostat needs adjustment. See Calibrating Oven Temperature, Page 13.
Replace or reinsert the light bulb if loose or defective. See Page 29. Touching the bulb with
fingers may cause the bulb to burn out.
Check for obstruction in oven door. Check to see if hinge is bent.
There may be a soil build-up around the lens cover. Wipe lens cover area with a clean dry
towel prior to attempting to remove the lens cover.
Allow the oven to cool before running Self-Clean. Always wipe out loose soils or heavy spill-
over before running Self-Clean. If oven is badly soiled, set oven for a four-hour
Self-Clean. See Preparing the Oven to Self-Clean, Page 24.
Make sure there is proper electrical power to the oven. See the Clock and Timer sections on
Page 12.
When using Bake mode, preheat the oven first. Convection Bake and Convection Roast will
eliminate any moisture in oven (this is one of the advantages of convection).
When oven racks are removed and replaced, always tilt racks upward and do not force them to
avoid chipping the porcelain.
Models SOVB - DOVB
Problem Solving Steps
Use & Care Manual
ENGLISH
31