Setting The Self-Cleaning Mode; To Set The Self-Cleaning Mode; To Change The Cleaning Time; To Delay The Start Of Cleaning - FULGOR SOVB Manuel D'utilisation Et D'entretien

To Set the Self-Clean Mode
1. Press UPPER/LOWER key to select the cavity
to be cleaned, if the oven is a double.
2. Rotate both knobs into the clean position.
3. CLEAN & TIME appear.
4. The number of cleaning hours is displayed
automatically, standard cleaning time is 3 hours.
5. At the end of the programmed cleaning time,
the oven will automatically turn off.
6. To stop the cleaning mode at any moment,
move one of the two knobs from the cleaning
position.
Do not attempt to open the door while the door is
locked. The lock symbol will flash until the motor stops.
When the lock symbol is displayed, the door cannot be
opened. Check that the door has been locked and will
not open before starting the Self-Clean mode.
If door does not lock, rotate the cooking mode knob into
the OFF position and do not start self-clean; phone for
service.
If the door is in the open position when this mode is
selected, the lock symbol will flash until the door is
closed. The latch doesn't move.

To Change the Cleaning Time

1. To change the setting from 3 hours, select
either 2 hours for light soil or 4 hours for heavy
soil immediately before starting.
2. To change the hours, touch the COOK TIME
key.
3. The number of hours for cleaning will flash.
4. Use INC or DEC buttons to change the number
of hours.
Setting the Self-Clean Mode
Press COOK TIME or wait a few seconds to confirm the
new value.

To Delay the Start of Cleaning

TO CHECK CLEAN TIME OR STOP TIME during
a delayed clean, simply press COOK TIME
or STOP TIME buttons.
Use & Care Manual
Models SOVB - DOVB
5. To change the minutes, touch the COOK TIME
key.
6. The number of minutes for cleaning will flash.
7. Use INC or DEC buttons to change the number
of minutes. Hold the key to change by 10
minutes.
1. Follow steps 1 through 7 above.
2. Touch the STOP TIME key and the hour to stop
will begin flashing.
3. Use INC or DEC buttons to change the stop
hour.
4. To change the minutes, touch the STOP TIME
key.
5. The minutes to stop cleaning will flash.
6. Use INC or DEC buttons to change the minutes.
Hold the key to change by 10 minutes.
7. Press STOP TIME or wait a few seconds to
confirm the new value.
8. Oven door will lock and display shows DELAY.
9. When the delay time ends, cleaning will start.
10. At the end of the programmed cleaning time,
the oven will automatically turn off.
11. END will appear on the display, CLEAN & TIME
will flash until any time key is touched or the
knob is moved to the OFF position.
ENGLISH
25