Publicité
Les langues disponibles
Les langues disponibles
9. Attach the base unit or the camera
mounting bracket to the camera
mounting stage.
Insert and tighten the 4 screws (M4, acces-
sory)
(Recommended tightening torque:
1.57 N
m {1.16 lbf
•
Note:
•
Which component to attach depends
on the camera model. The base unit is
a main unit component of the camera
and the camera mounting bracket is an
accessory of the camera.
•
The base unit is attached in figures
shown in the following descriptions.
Important:
•
Make sure to attach the camera mounting bracket in correct direction. If you attempt to
attach it in the wrong direction, some part of it will interfere with the camera mounting
stage. Do not try to forcibly attach it as it may cause a failure or falling.
Correct direction
ft})
•
Base unit
Camera mounting bracket
* Make sure to
attach it in cor-
rect direction.
Wrong direction
9
Publicité
