Publicité
Les langues disponibles
Les langues disponibles
Wiring—conventional systems
Alternate wiring (conventional systems)
If labels do not match terminals, connect wires as shown below (see notes, below).
NOTES:
1. If you must connect both
R and Rc wires, set the
R Slider Tab to the down
position (2 wires).
2. If your old thermostat
had both R and RH wires,
set the R Slider Tab to
the down position (2
wires). Then connect the
R wire to the Rc terminal,
and the RH wire to the R
terminal.
3. If your old thermostat had only 1 C or C1 wire, connect it to the C terminal. If
your old thermostat had 2 C or C1 wires, wrap each separately with electrical
tape and do not connect them.
4. C does not power the thermostat display or operations; batteries are always
required.
Wiring—heat pump
Connect wires: heat pump
1
Match each labeled wire with same letter on new thermostat.
2
Insert the wires into the matching terminal.
NOTE: If you have difficulty inserting wires, you may have to press down the
terminal push button next to the corresponding terminal.
Labels don't match?
If labels do not match letters on thermostat, see "Alternate wiring
(conventional systems)" above.
S
A
L/A
S
O/B
Y
W
2
AUX
Y
E
G
W
K
C
U
R
U
Rc
11
RTH5160 Series
Publicité
