Scheppach AWH-500FL Traduction Des Instructions D'origine page 23

any broken parts, or mounting fixtures,
and any other condition that may affect
proper operation. Any part that is dam-
aged should be properly repaired or re-
placed by a qualified technician. Do not
use the helmet if any switch does not
operate properly.
• Replace parts and accessories. When
servicing, use only identical replacement
parts. Use of any other parts can render
helmet in effective, possibly cause eye
damage, and will void the warranty. Only
use accessories intended for use with
this helmet. Accessories are available
from After Sales Support.
• Do not weld if under the influence of alco-
hol or drugs. Read warning labels on pre-
scriptions to determine if your judgment
or reflexes are impaired while taking
drugs. If there is any doubt, do not weld.
• Maintenance. For your safety, service
and maintenance should be performed
regularly only by a qualified technician.
• This helmet provides protection for in-
tended purpose only. There are certain
applications for which this helmet was
designed. Do not modify this helmet and
do not use this helmet for a purpose for
which it was not intended.
• The welding helmet with automatic dark-
ening is not suitable for laser and gas
welding.
• Please ensure that you have set the au-
tomatic darkening before each welding
procedure.
• Only use the welding helmet in temper-
atures between -5 °C and +55 °C. The
filter's reaction time will slow down if this
temperature has not been reached or is
exceeded.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
• The welding helmet will not protect
against severe impact hazard.
• The welding helmet will not protect
against explosive devices or corrosive
liquids.
• Maintain the helmet and lens correctly to
help ensure reliable protection:
- Clean filter's surfaces regularly. Keep
sensors and solar cells clean using
a clean lint- free tissue/cloth. Do not
use any solvents on filter's screen or
helmet components. Protect filter from
liquid and dirt contact. Do not immerse
the filter in water.
- Should the auto dimming welding hel-
met not darken upon striking an arc,
stop welding immediately and have
the helmet checked by a qualified ser-
vice technician.
- Replace the front lens cover if it be
comes cracked, scratched, pitted, or
otherwise damaged.
- Do not any modifications to either the
Auto- Darkening Filter or the rest of
the helmet, other than those spec-
ified in this manual. Do not use any
replacement parts other than those
specified in this manual. Unauthor-
ised modifications and replacement
parts will void the warranty and ex-
pose the user to the risk of personal
injury. Do not open or tamper with the
Auto- Darkening Filter.
• Do not place the helmet's Auto- Darken-
ing Filter on a hot surface.
• Severe personal injury and/or blindness
may occur if the user fails to follow the
afore mentioned warnings and/or fails to
following the operation instructions.
GB | 23