Husqvarna DSS200 Notice D'utilisation page 67

General
WARNING! The user must only carry out
!
the maintenance and service work
described in this Operator's Manual.
More extensive work must be carried out
by an authorized service workshop.
All operations described in this section
must be performed with the tool
dismounted from the machine and
positioned on the ground.
Use personal protective equipment as
well as equipment to mechanically
secure machine components during
maintenance and service.
The life span of the machine can be
reduced and the risk of accidents can
increase if machine maintenance is not
carried out correctly and if service and/or
repairs are not carried out professionally.
If you need further information please
contact your nearest service workshop.
• Let your Husqvarna dealer regularly check the
machine and make essential adjustments and repairs.
Maintenance schedule
In the maintenance schedule you can see which parts of
your machine that require maintenance, and with which
intervals it should take place. The intervals are calculated
based on daily use of the machine, and may differ
depending on the rate of usage.
Daily maintenance
Cleaning
General inspection
Cutters
Lubrication
Cleaning
• Clean with a rag or brush.
• The tool can be cleaned more thoroughly by washing
it with water and detergent.
MAINTENANCE
General inspection
• Check the tool for damage and wear.
• Check that all couplings, connections and hydraulic
hoses are in full working order. Replace if necessary.
• Make sure that the bolts are not loose. Tighten the
bolts with a torque wrench if necessary.
Torque, Nm
A
B
Cutters
Always use genuine parts.
• Check the cutters. The blades should be changed
when more than 2 mm of the radius is cracked.
NOTICE! Damaged shearers can cause damage to the
tool. Never use cutters that are cracked or damaged.
Inspect the wear on the cylinder head wear plate when
changing blade and change of necessary.
Spanner size, mm/ inch
380 17
140 55
>2mm
A
B
Quantity
2
1
–
English 67