Sharp CD-BK100W Mode D'emploi page 22

Recording to a Cassette Tape (continued)
CD-BK100W
„ Recording from the radio
1
Tune in to the desired station. (See page 16.)
2
Load a cassette into the TAPE 2 cassette compartment.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the REC PAUSE
ton.
Recording will be paused.
4
Press the / (TAPE 2 ) button.
To interrupt recording:
1 Press the REC PAUSE
"REC" will flash.
2 Press the / (TAPE 2
"REC" will appear.
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise whilst recording an AM station, move the AM loop aerial.
Erase-prevention tab of cassette tapes:
z When recording on a cassette tape, make
sure that the erase-prevention tabs are not re-
moved. Cassettes have removable tabs that
prevent accidental recording or erasing.
z To protect the recorded sound, remove the tab
after recording. Cover the tab hole with adhe-
sive tape to record on the tape without the tab.
E-21 ENGLISH
( ) but-
( ) button.
) button to resume recording.
Tab for side B
Listening to the Radio (See page 16.)
„ Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into
the TAPE 1 cassette compartment.
Insert a blank tape into the TAPE 2
cassette compartment.
It is recommended that the recording
tape is the same length as the master
tape.
3
Press the TAPE (1
"TAPE 1" appears on the display.
4
Press the REC PAUSE
ton.
Recording will be paused.
5
Press the / (TAPE 2 ) button.
To stop dubbing:
Press the (TAPE ) button.
TAPE 1 and TAPE 2 will simultaneously stop.
„ Erasing recorded tapes
Side A
1 Load the tape to be erased into the TAPE 2 cassette compartment with the side to
be erased facing toward you.
2 Press the TAPE (1
3 Press the REC PAUSE
Tab for side A
4 Press the /
Note:
Make sure that the TAPE 1 is not in use.
2) button until
( ) but-
2) button until "TAPE 2" appears on the display.
( ) button.
(TAPE 2 ) button to start erasing.