Remote Control; Connecting The Receiver; Replacing The Batteries In The Receiver; Inserting Or Replacing The Batteries In The Remote Control - Dru COLOURLINE G31 Instructions D'installation Et Mode D'emploi

• Take the black and yellow chips from their bags and
spread them equally over the tray surrounding the burner.
• Make sure that no vermiculite gets on or into the pilot
light burner, as this could prevent it from working proper-
ly.
• Do not place any chips on the burner tray.
• Now lay the rest of the logs in place as illustrated in fig. 5.
The logs should not be laid in any other way as this could
cause the formation of soot. Neither should the logs touch
pilot light burner.
You can "play" with the flames by moving the vermiculite,
embers and chips about on the burner bed until you have
created the desired flame effect.
Do not use any materials other than those supplied.The
supplied materials are incombustible and have been manu-
factured specifically for this appliance.

Remote control

Remote control is supplied as a standard accessory.The
heater has a freely adjustable. Batteries, with a life
expectancy of approximately one year, feed the electrical
supply.The remote control will only work if the pilot light
is lit.

Connecting the Receiver

The remote control system comprises a receiver and a
remote control, packed together in one box. The receiver
must be connected to the appliance fitting the batteries.
This is done as follows:
• Take the receiver out of the box.
• Slide the white plug of the cable onto the receiver circuit
board (fig. 8).
• Connect the wires to the connectors on the gas control
valve.The different sized plugs correspond with the con-
nectors on the gas control valve.
• Open the lid.
• Insert 4 penlight batteries (type AA). Make sure they are
the right way round.
• Replace the lid.
• Place the receiver of
the remote control
under the appliance
on the floor. Make
sure that the red
"LED" points for-
wards. Place the
reciever as far away
from the burner tray
as possible to prevent
the reciever from
getting too hot.

Replacing the batteries in the receiver

• Open the door at the front.
• Take the receiver and open the cover.
The batteries are under that cover.
• Remove the old batteries and insert the new ones, making
sure that the + and – signs on the batteries correspond
with those in the holder.
Inserting or replacing the batteries
in the remote control
• Remove the cover on the back of the remote control.
• Connect a square battery (type 6LR61) to the clip.
• Fit the battery in the holder.
• Replace the cover.
• The temperature is shown on the display in Fahrenheit,
press both buttons for a few seconds and it will change to
Celsius.
NB: Do not throw old batteries in the dustbin.They
should be treated as Chemical Waste.
For the optimal functioning and longer useful life of its
appliance, Dru advises the use of Duracell batteries.
fig. 8
17
INSTRUCTIONS FOR INSTALLATION
Colourline / Quadro / Avanto