Features; Starting The Ice Machine - GE UNC15 Manuel D'utilisation Et Instructions D'installation

Features

Starting the ice machine

This machine takes in room temperature air at the lower
right front and forces warm air out the lower left front.
Restricting the airflow or operating the machine in a hot
or cold environment will adversely affect the ability of the
ice machine to make ice.
When the door is opened, the control panel, ice making
area and ice storage bin are visible. The scoop is located
in a holder along the right side wall.
This is a gravity drain model that must have a building
drain connection below the level of the drain tube at the
back of the cabinet. A pump can be installed, which can
to be located where a gravity drain isn't available.
Accessories on page 21 for more information on the
drain pump.
Initial Start Up
1. Turn on the water supply.
2. Switch on the electrical power.
switch will glow white.
6
Control panel
Ice scoop
POWER CLEAN
ON/OFF ICE CHECK TIME TO RESET
MAKING WATER CLEAN
See
dropping nugget ice into the storage bin. It is normal for
that ice to melt and continue to melt but at a slower rate
as the bin cools. It will take about 6-7 hours to fill up the
when full.
Discard the first bin full of ice.
Air Intake
Warm Air Out
49-1000436 Rev. 0