User Manual - SBS Runner Bt 600 Mode D'emploi

UK

USER MANUAL

Overview
On the right "R" headset there is:
- Micro USB port for power cable connection;
- LED indicator;
- Microphone;
- MFB multi-function panel (ON/OFF - Bluetooth association - play/
pause - answer/end call - call/reject - call/call last number;
- "+" button (Volume up - next track);
- "-" button (Volume down - previous track).
Recharging information
1 - insert the power cable with the micro USB side into the
headphones;
2 - insert the cable with the USB side into a computer or USB
charger (not included);
3 - the red LED lights up during charging;
4 - a complete recharge takes about 2 hours;
5 - the red LED turns off when the charging is complete.
Connecting the headphones
1 - Press and hold the MFB button (centre - multifunction button)
for 5 seconds until the LED fl ashes alternately in Red/Blue - you
will hear "Power ON".
2 - Activate the phone's Bluetooth, search and select the SBS
BT600 headphones to connect with - you will hear "Connected".
3 - Once the headphones are connected to the phone, under
normal conditions the LED will slowly fl ash blue.
IMPORTANT:
after carrying out the connection procedure for the fi rst time, for
subsequent connections with the same phone, just hold down the
MFB button (for 5 seconds); the LED will fl ash alternately in Red/
Blue - you will hear "Power ON" and immediately afterwards you
will hear "Connected": the headphones will then be connected
automatically (LED slowly fl ashing Blue).
USING THE HEADPHONES
Switching on/Connecting:
Switch on the headphones by pressing the MFB button (central -
multifunction button) for 5 seconds until the red/blue LEDs fl ash
alternately - you will hear "Power ON" - the headphones are now
ready to connect with the smartphone.
4