User Manual - SBS Runner Flash Mode D'emploi

UK

USER MANUAL

Charging the base.
With the included USB/micro-USB cable: insert the micro-USB
end into port 'A' of the charging case, and the USB end into a
PC or travel charger port. The blue LEDs inside the case (B) will
illuminate in sequence to indicate progress of charging.
Charging the earbuds.
Place both earbuds in the charging case: the LEDs (C) will
illuminate fixed red to indicate that charging is in progress. When
charging is complete they will temporarily turn blue and then turn
off.
Activation and pairing
Make sure you have turned off Bluetooth® on your smartphone.
Hold down the MFB button (the only button on the earbuds) for
a few seconds, until both 'C' LEDs flash red and blue alternately.
Wait a few seconds until the earbuds recognise and pair with each
other (this will be confirmed by the voice message: 'connected').
Only at this point, activate Bluetooth® on your smartphone.
As soon as the pair of earbuds is recognised, select (SBS
FLASH RUNNER) from the list: the LEDs will turn off to confirm
successful pairing. If only one earbud has been paired by mistake,
unpair it and repeat the procedure from scratch. After the first
connection, the earbuds will automatically pair on removing them
from the charging case.
Functions summary.
Answering a call: press MFB once quickly
Ending a call: press MFB once quickly
Rejecting a call: press and hold MFB for about two seconds
Redialing the last number: press MFB twice quickly
Play/pause music: during playback, press MFB quickly
Play track from beginning: press left MFB three times quickly
Next track: press right MFB three times quickly
Power off.
Press and hold the MFB buttons until the LED 'C' flashes red once
to indicate power off, or insert the earbuds into the charging case
and close it.
4