Installation Instructions - GE JCBP62 Mode D'emploi

Masquer les pouces Voir aussi pour JCBP62:
Table des Matières

Publicité

Installation
Instructions
Questions? Call 1.800.361.3400 or Visit our Website at: www.GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
IMPORTANT
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions
for future reference.
• Skill level – Installation of this appliance
requires basic mechanical skills.
• Product failure due to improper installation
is not covered under the Warranty.
WARNING
be properly connected by means of the
supplied cord and plug. If your kitchen does
not have a receptacle, you must have one
installed by a licensed electrician.
FOR YOUR SAFETY:
WARNING
installation, switch power off at service panel
and lock the service disconnecting means
to prevent power from being switched on
accidentally. When the service disconnecting
means cannot be locked, securely fasten a
prominent warning device, such as a tag,
to the service panel.
All rough-in and spacing dimensions must be
met for safe use of your range. Electricity to
the range can be disconnected at the outlet
without moving the range if the outlet is in
the preferred location (remove lower drawer).
— Observe all
— This appliance must
— Before beginning the
Free-Standing
Electric Ranges
FOR YOUR SAFETY:
To reduce the risk of burns or fire when reaching
over hot surface elements, cabinet storage space
above the cooktop should be avoided. If cabinet
storage space is to be provided above the
cooktop, the risk can be reduced by installing a
range hood that sticks out at least 12.5 cm (5")
beyond the front of the cabinets. Cabinets
installed above a cooktop must be no
deeper than 32.5 cm (13").
Make sure the cabinets and wall coverings
around the range can withstand the temperatures
(up to 93.3 °C [200°F]) generated by the range.
ANTI-TIP DEVICE
WARNING
of tipping, the appliance must be secured by
properly installed Anti-Tip bracket packed
with this appliance.
If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB2X7909.
• All ranges can tip
• Injury to persons could result
• Install Anti-Tip bracket packed
with range
• See Installation Instructions
If you pull the range out and away from the
wall for any reason, make sure the Anti-Tip
bracket is engaged when the range is pushed
back against the wall.
REMOVE SHIPPING MATERIALS
Remove packaging materials. Failure to
remove packaging materials could result in
damage to the appliance.
NOTE: Cut the orange shipping ties from the
power cord, being careful not to damage the
cord.
30
— To reduce the risk
WARNING

Publicité

Table des Matières
loading

Table des Matières