Operating Principle; Description Of The Machine; Installation; Operating Instructions - Tecno-gaz Unika Plus Mode D'emploi

7

OPERATING PRINCIPLE

To dry the instrumentation, the machine generates a flow of hot air that flows on the objects and removes
their moisture as vapour.
One fan locate in the top part of the machine convey the air into electric resistance; that heat the air which is
blown into the instrumentalism below.
The water remaining on the surface of the instrumentation evaporates and is conveyed outside by the air
flow.
8

DESCRIPTION OF THE MACHINE

The device dryer is an AISI 430 stainless steel compact case (see picture A, B) supported by four rubber
feet. The front includes control panel, with a luminous main scale switch and a mechanic-electrical timer to
adjust treatment time (see picture A pos. 1, 2).
The door to the drying chamber is located under the front control panel (see picture A pos. 3).
The air intakes for the motor-fan is on the side of the machine.
The back includes the fuses and the mains lead (see picture B, pos. 5, 6); the moisture discharge grid is in
the bottom part.
The drying chamber contains a removable tray, upon which the objects to be dried are laid.
9

INSTALLATION

The machine must be placed on a stable flat surface, far from other equipment and not inserted in narrow
spaces since the machine produces heat and emits water vapour, albeit in small quantity.
It must be connected to an electric socket supplying 1 KW power and 230 V voltage and equipped with a
safety cut-out.
10

OPERATING INSTRUCTIONS

Place the objects on the dedicated tray after having washed them with water and let them drip thoroughly.
The objects must be spread on the tray net and not be touching or overlapping, to allow the air to flow on
their surface, heat them, remove moisture and flow out into the chamber below.
Insert the tray with the objects into the drying chamber, close the door and turn on the main switch (see
picture A pos. 1).
Fan starts to work immediately.
Activate the resistance, that heats the air, setting the drying time (max.4 min) with the timer hand-grip (fig.A
pos.2).
At the end of the set time, the resistance stops automatically and only the fun will work.
If you switch off the main switch the fan stops too.
Open the door and check if the items are dried.
If the drying time was not sufficient, turn the objects upside down and repeat the operation.
Objects characterized by a cavity retaining water must be dripped thoroughly before undergoing the
treatment and disassembled as much as possible before being placed on the tray.
Flat objects tend to remain humid on the surface touching the tray net; therefore, to achieve a correct drying,
they need to be turned upside down and undergo a new treatment.
- 23 -
ENGLISH