ChefLine IFM7 Notice D'utilisation page 31

5 POSSIBLE FAULTS
Fault
The machine does
not start
The spiral turns
sporadically
6 INFORMATION FOR DEMOLITION AND DISPOSAL
Demolition and disposal of the machine is the sole responsibility of the owner, who must perform
these tasks in compliance of currently enforced laws pertaining to safety and environmental
protection in the country where the machine is installed.
Disassembly and disposal can also be performed by a third party, as long as an authorized entity
for recovery and demolition of the materials in question.

INSTRUCTION: always adhere to the currently enforced laws pertaining to disposal of materials
and in the country where the machine is installed , and any possible necessity for registration of
demolition.
!
WARNING: All disassembly operations for demolition must take place with the machine shut-
down and disconnected from the electrical power supply.
- remove all electrical apparatus;
- separate the accumulators on the electronic cards;
- dispose of the machine structure through authorized entities;
!
WARNING: Abandoning the machine in accessible areas constitutes grave danger for persons
and animals.
Responsibility for possible damages to persons and animals is falls exclusively on the owner.
Cause
Lack of electrical
energy
The emergency stop
button is inserted
The protection grating
and/or the head are
lifted
The main switch knob
is in position "0"
The timer knob is in
position "0"
The chain is loose
- 31 -
Remedy
Check the main
switch, socket, plug
and power supply
cable
Turn the button in the
direction indicated by
the arrow
Correctly lower both
the protective grating
and the head
Turn the knob to
position "1"
Set the knob from 1 to
30 minutes
Tension the chain as
described in section
7.2.2