Publicité
Les langues disponibles
Les langues disponibles
2610055543.qxp_GKT18V-20GC 5/26/20 4:37 PM Page 23
TEMPERATURE INDICATOR
If the temperature indicator 20g is glowing
yellow, the critical temperature of the
motor, electronics or battery has been
reached. Run the power tool at no load and
allow it to cool down.
If the temperature indicator is glowing red,
power tool is overheated and will switch
off. Allow the power tool to cool down.
SMARTPHONE STATUS INDICATOR
It is necessary to purchase and install a
Bosch connectivity module and install the
'BoschToolbox' app to receive information
and
messages
smartphone status indicator. See the
Connectivity chapter on the next page.
Green Smartphone status indicator 20e
means that there is non-critical information
available in the 'Bosch Toolbox' app for
user to read.
Yellow smartphone status indicator 20e
means that there is important information
available (e.g. temperature warning).
Red smartphone status indicator 20e
means that there is critical information
available. It is recommended that the user
reviews the message immediately.
POWER TOOL STATUS FRAME
Green light of the power tool status frame
20f means everything is functioning
properly.
Yellow light means that:
a.
Critical temperature has been reached
(the temperature indicator 20g is also
glowing yellow) - run the tool at no load
and allow it to cool down, or
b.
Battery is almost depleted (the battery
charge indicator 20a is also glowing
yellow) - charge or replace the battery
soon.
Red light means that:
a.
The tool is overheated (the temperature
indicator 20g is glowing red) – turn the
tool off and on again, or
b.
Battery is depleted (the battery charge
indicator 20a is also glowing red) -
charge or replace the battery.
Flashing blue light means that the power
tool is connected to a mobile device or
settings are being transferred. The user
must press the user interface button 20c to
accept and store the new setting(s).
Operating Instructions
as
alerted
by
the
D
A
Connectivity
operating instructions included with
Bosch connectivity module. Operating
instructions for connectivity module
include important information not covered
in this manual.
This power tool is Bluetooth capable and
select features can be adjusted remotely
using a mobile device. Utilizing these
features requires installation of a Bosch
Bluetooth connectivity module and a
mobile device with the Bosch Toolbox app
installed.
If connectivity module is not purchased
with the tool, or if the replacement of the
module or the battery becomes necessary,
please follow this procedure (See Fig. 25):
-
Using a flat screwdriver or a coin,
remove
the
connectivity module compartment 21, by
turning it 1/4 turn counter-clockwise.
-
If the tool is already equipped with the
connectivity module, remove the battery
B, but do not remove the connectivity
module C.
-
If the connectivity module is installed for
the first time, remove the plastic
placeholder D from the connectivity
module compartment, and place the
connectivity
23
21
B
C
To reduce the risk of
injury
read
the
cover
A
from
the
module
C
in
the
Publicité
