Publicité
Les langues disponibles
Les langues disponibles
2610055543.qxp_GKT18V-20GC 5/26/20 4:36 PM Page 15
do not interfere with the lower guard, or
the cutting operation at all settings.
DUST PORT
The dust port 18 swivels so that dust can
be directed in the desired direction
(Fig. 4).
DUST BAG
Using Dust Bag – To attach the empty dust
bag 18a, press-fit its coupler end into the
saw's dust port 18 (Fig. 4).
Cleaning Dust Bag – After the dust bag is
2/3 to 3/4 full, remove it from the saw.
Bring the bag to a proper container and
pull open the zipper located on the bottom
of the bag. Hold the bag by the coupler end
and shake it vigorously until all the dust
and debris fall from it. Close zipper and
reattach the bag.
NOTE: Clean the bag at the end of the
cutting session and before transporting or
storing the saw.
Materials in fine particle form may be
explosive. Do not throw sawdust on an
open fire. Spontaneous combustion, in
time, may result from the mixture of oil or
water with dust particles.
Saw Assembly
Be extremely careful
when disposing of dust.
CONNECTION TO VACUUM CLEANER /
DUST EXTRACTOR
Connect the vacuum cleaner hose to the
dust port (Fig. 4).
-
Bosch VH-series hoses - The VX120 hose
adapter is required (included with VH-
series hoses).
-
Other 35mm and 22mm hoses, such as
the Bosch VAC-series hoses - Connect
hose directly to the tool.
-
Common 1¼" or 1½" hoses - The Bosch
VAC024 adapter is required (sold
separately).
Connect the vacuum hose to a vacuum
cleaner.
The vacuum cleaner must be suitable for
the material being worked on.
When vacuuming dry dust that is
especially detrimental to health or
carcinogenic, use a special vacuum
cleaner / dust extractor.
15
Publicité
