Télécharger Imprimer la page

WAGNER ProjectPro 213 Extra Mode D'emploi page 30

Publicité

Les langues disponibles

Les langues disponibles

GB
F
Should the moulded plug have to be replaced, never re-use the defective plug or attempt to plug
it into a different 13 A socket. This could result in an electric shock.
 Should it be necessary to exchange the fuse in the plug only use fuses approved by ASTA in
accordance with
BS 1362. 5 Amp fuses may be used.
 To ensure that the fuse and fuse carrier are correctly mounted please observe the provided
markings or colour coding in the plug.
After changing the fuse, always make sure that the fuse carrier is correctly inserted. With out the
fuse carrier, it is not permissible to use the plug.
 The correct fuses and fuse carriers are available from your local electrical supplies stockist.
The guarantee period amounts to 24 months in case of private use, and to 12 months
in case of commercial use. If the amount of paint processed with the unit exceeds
1,000 litres, this is considered to be commercial use.
We give a works guarantee to the following extent for this unit:
All those parts that prove to be unserviceable or to be considerably impaired in their
serviceability within the guarantee period since the point of handing over to the
buyer due to a circumstance lying before this handing over – in particular due to
faulty design, bad building materials or poor execution – are improved or supplied
new as we choose without costs.
We do not accept any guarantee for damage that has been caused by the following
reasons:
Unsuitable or incorrect usage, faulty mounting or starting-up by the buyer or by
third parties, natural wear - wear parts are not covered by the WAGNER guarantee ,
faulty handling in particular inadequate cleaning or maintenance, unsuitable coating
materials, substitute materials and chemical, electrochemical or electrical influences,
in as far as damage is not due to our fault. Abrasive coating materials, such as
dispersions, glazes, quartz undercoats, abrasive materials, etc. reduce the durability of
valves, packings, spray guns, tips, cylinders, pistons, filters, hoses, seals, etc.
Any resulting signs of wear are not covered by this guarantee. The unit is not
conceived for use in shift work or for lending or leasing – these uses are excluded from
the guarantee.
The replacement of a part does not extend the guarantee period of the unit.
The unit has to be examined immediately after receipt. Obvious faults are to be
reported in writing within 14 days after receipt of the unit in order to avoid loss of the
rights arising from faults.
We reserve the right to have the guarantee fulfilled by a contractual company.
Repairs going above and beyond those dealt with in these operating instructions
are reserved for our factory. In case of a guarantee case or repair, please contact the
specialist dealer from whom you purchased the unit.
Fulfilling of the guarantee depends on proof being provided by invoice and delivery
note or proof of purchase.
If the check shows that the case is not a guarantee case, repairs are carried out at the
expense of the buyer.
Claims against Wagner that are based on or caused by the failure or insufficiency of a
unit cannot be asserted.
We make it clear that the guarantee declaration does not represent a limitation of the
statutory rights or of the rights agreed contractually through our general terms of
business.
24
24
Guarantee declaration
ProjectPro 213 Extra
ProjectPro 213 Extra

Publicité

loading