Getting Started; Operating This Unit; About Operation Mode; Dsp - Sony XDP-210EQ Mode D'emploi

Getting Started

Operating this unit

You can control this unit by a Sony Master
unit.
Some master units have (+)/(–) (volume)
buttons, and some have a dial.
This instructions shows as follow.
Rotate/press (+) or (–).
Note
There may be a difference between the display items of this
manual and the master unit.
Note in operation
• The unit has a digital volume control system.
Do not down the volume of the master unit
too much as doing so may cause the sound
quality to deteriorate.
EN
• When you connect this unit to the master
unit, the loudness function will not work.
• The sound becomes unclear in some
situations (such as when the BAS, TRE or EQ
are excessively boosted).
• Two units can not be used at same time.

About operation mode

This unit has three operation modes.
Sound Control Mode
Select the item or adjust it partially.
• EQ (Graphic Equalizer): Select the equalizer
curve.
• POS (Listening Position): Select the listening
position.
• SUB (Subwoofer): Adjust the subwoofer
volume level.
Sound control mode can adjust not only BAS,
TRE, BAL, FAD but also VOL. For further
details, read the master unit instructions.
Sound Tuning Mode
Tune in the item selected in the Sound Control
Mode exactly.
• EQ (Graphic Equalizer): Setting and
registering the equalizer curve.
• POS (Listening Position): Adjust the
listening position.
• CNW (Cross Over Network): Adjust the cut-
off frequency.
Name Edit Mode
EQ (Graphic Equalizer): Naming the equalizer
4
curve.
Actual total number:

DSP

Selecting the stored
equalizer curve
— Sound Control Mode
You can select the stored equalizer curve
(MEMORY1 to MEMORY9) or an unadjusted
curve (FLAT).
1
Press (SOURCE) to select a source (radio,
tape, CD or MD etc.).
2
Press (SOUND) repeatedly until "EQ"
appears.
EQ
1 MEMORY1
SUR EQ
3
Rotate/press (+) or (–) to select the
stored equalizer curve.
After three seconds, the display goes back
to the normal playback mode.
Tip
To adjust the stored equalizer curve further, press
(SOUND) for two seconds within three seconds after
following step 3 above. Then go to step 4 to 8 of "Setting
and storing the equalizer curve."
Setting and storing the
equalizer curve
— Sound Tuning Mode
You can adjust the 21 band frequencies to
make an equalizer curve, and store up to nine
curves.
Front (18 band):
30 Hz, 45 Hz, 62 Hz, 90 Hz, 130 Hz, 190 Hz,
270 Hz, 400 Hz, 580 Hz, 840 Hz, 1.2 kHz,
1.7 kHz, 2.5 kHz, 3.6 kHz, 5.2 kHz, 7.5 kHz,
11 kHz, 16 kHz
Rear (3 band):
90 Hz, 840 Hz, 7.5 kHz
1
Press (SOURCE) to select a source (radio,
tape, CD or MD etc.).
2
Press (SOUND) for two seconds.
Sony XDP-210EQ (E) 3-856-153-12 (1)