Labeling An Equalizer Curve - Sony XDP-210EQ Mode D'emploi

3
Press (SOUND) repeatedly until "EQ"
appears.
EQ Tuning
1 MEMORY1
SUR EQ
4
Rotate/press (+) or (–) to select an
equalizer curve.
5
Adjust the equalizer curve.
1 Press (4) (n) to select the desired
frequency.
F30 n F45 n .........n F16k n
R90 n R840 n R7.5k
EQ 1 MEMORY1
F 3‚ +12
SUR EQ
If you press (1) (N), the frequency
appear in the reverse order.
2 Rotate/press (+) or (–) to adjust the
level.
Note
If you adjust the level too high, the sound becomes
distorted. In this case, lower the level until the
sound becomes normal.
3 Repeat steps 1 and 2 to adjust the
equalizer curve.
6
Press (5) (ENTER).
ENT Number?
1 MEMORY1
SUR EQ
7
Rotate/press (+) or (–) to select the
number that you want to enter into
memory.
8
Press (5) (ENTER).
EQ
+Enter+
SUR EQ
9
To return to the normal playback mode,
press (SOUND) for two seconds.
To cancel setting the equalizer curve, press
(SOUND) for two seconds after step 7.
Tip
You can label the equalizer curve by pressing (LIST) for
two seconds after step 5 above. Then go to step 2 to 7 of

"Labeling an equalizer curve".

Note
If the name of the equalizer curve flashes in the display
window, the equalizer curve is not stored. To store the
equalizer curve again, repeat steps 6 to 9 above.
Actual total number:
Labeling an equalizer
curve
— Name Edit Mode
You can label each equalizer curve with a
personalized name. You can enter up to eight
characters for an equalizer curve.
1
Press (SOUND) for two seconds.
2
Select an equalizer curve and press
(LIST) for two seconds.
3
Enter the characters.
1 Rotate/press (+) to select the desired
characters.
(A n B n C n .... Z n 0 n 1 n 2 n
... 9 n + n – n * n / n \ n > n <
n . n _)
EQ Name
1 MEMORY1
SUR EQ
If you rotate/press (–), the characters
appear in the reverse order.
If you want to put a blank space between
characters, select "_" (under-bar).
2 Press (4) (n) after locating the
desired character.
The flashing cursor moves to the next
character.
EQ Name
1 CEMORY1
SUR EQ
If you press (1) (N), the flashing cursor
moves to the left.
3 Repeat steps 1 and 2 to enter the
entire name.
4
Press (LIST) for two seconds.
5
Press (5) (ENTER).
6
Rotate/press (+) or (–) to select the
number that you want to enter into
memory.
7
Press (5) (ENTER).
EQ
+Enter+
SUR EQ
8
To return to the normal playback mode,
press (SOUND) for two seconds.
Tip
To erase/correct a name, enter "_" (under-bar) for each
character.
Note
When the name of the equalizer curve flashes in the display
window, the equalizer curve name is not stored. To store the
equalizer curve again, repeat the step 5 to 7 above rightly.
Sony XDP-210EQ (E) 3-856-153-12 (1)
EN
5