Setting Up And Fixing The Unit On The Stand - Rational 2-XS Mode D'emploi

4 | Transport and setting up
Securing unit with stainless steel feet
The stand with stainless steel feet can be
fixed to the floor with dowels and screws,
by gluing it with a special adhesive or by
welding.
Securing stand with castors
NOTICE
Damage to the connections due to
moving
Secure the unit additionally with a wall
mounting chain to prevent shifting on
the rear wall. The wall mounting chain
is not included.
1. There are holes on the back of the
stand that are used for attachment to
the wall [ Photo
2. In addition, tighten the locking brakes.
>>
The stand is secured and fixed against
rolling away.
4.5 Setting up and fixing the unit on
the stand
NOTICE
Improper setting up and improper
transportation
Set up the unit as described in the
installation manual. Incorrect transport
or installation may damage the unit.
a
If possible, the stand is aligned and
fixed to the installation surface.
1. Position the rear unit feet on the posi-
tioning pins of the stand.
>>
The unit is on the support table.
80.51.898_iVario-iVario_Pro_2-S_2-XS_Stands_V03_EU-west
10].
If you connect the unit to the mains, water
and waste water, route the connecting
cables through the openings in the stand. If
you do not use the openings, close them
using the plastic caps provided. Cable and
pipe penetrations made of rubber are in-
cluded in the scope of delivery for the
stand.
Fixing the unit to the stand
It is recommended that the unit is fixed to
the installation surface. A detailed descrip-
tion of how to fix the unit to the work sur-
face or the stand can be found in the ori-
ginal installation manual for the units
iVario 2-XS / iVario Pro 2-S.
Unit mounting kit.2-XS, 2-S:
n
60.76.118
With the kit, the unit can be fixed to
n
the stand.
en
15 / 88