Aligning And Fixing The Stand - Rational 2-XS Mode D'emploi

en
a
A tool with a wrench size of 17 mm is
ready for use.
a
A torque wrench (50 Nm) is ready for
use.
1. Mount the stainless steel feet on the
stand. Secure them each with one M10
screw. These are included in the scope
of delivery.
2. If necessary, use the pre-drilled holes
in the stainless steel foot for secure at-
tachment to the ground.
>>
The stand with stainless steel feet is
set up.
Setting up the stand with castors
a
The castors are ready for use.
a
An Allen key (8 mm) is ready for use.
a
A torque wrench (70 Nm) is ready for
use.
1. Screw on the 2 double castors with a
locking brake at the front and the 2
double castors without a locking brake
at the rear. [
2. Put the protective caps on the screws.
>>
The stand is set up with castors.
Setting up a stand with a plinth
a
1 plinth for the front and 2 plinths for
the sides of the respective stand size
are ready for use.
1. Attach the plinths to the sides and
front of the stand [
2. Make sure that the plinths are properly
attached.
3. Place the stand on the plinth.
4. If necessary, seal the plinth with silic-
one.
>>
The stand is set up with a plinth.
14 / 88
Photo 07]
Photo 08].
80.51.898_iVario-iVario_Pro_2-S_2-XS_Stands_V03_EU-west
4 | Transport and setting up

4.4 Aligning and fixing the stand

Align the support table
NOTICE
Stands with stainless steel feet, castors
or plinths cannot be aligned level using
the feet.
For stands with stainless steel feet,
n
castors or plinth, refer to the
alignment steps in the original
installation manual for the units
iVario 2-XS / iVario Pro 2-S.
Aligning the stand with feet
a
The stand is at its intended installation
surface.
a
The intended installation surface is
level.
1. Place the spirit level lengthways on the
right side of the stand.
2. Align the stand to the front right 1 and
to the rear right 2 using the unit feet.
[ Photo 9 (1)]
3. Place the spirit level in the transverse
direction in the middle of the stand
and level the stand to the front left 3
using the unit foot. [
4. Place the spirit level in the longitudinal
direction on the left side of the stand
and level the stand to the rear left 4
using the unit foot. [
>>
The support table is level.
Securing the stand
NOTICE
Stands with feet requiring no fixing
Photo 9 (2)]
Photo 9 (3)]