Lamona LAM1803 Mode D'emploi page 17

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva-
ted.
The hob deactivates.
Residual heat indicator
does not come on.
The heat setting changes
between two levels.
The sensor fields become
hot.
comes on.
comes on.
and a number come on.
Possible cause
You do not set the heat set-
ting for 10 seconds.
You touched 2 or more sensor
fields at the same time.
There is water or fat stains on
the control panel.
You put something on one or
more sensor fields.
You put something on the
sensor field
.
The zone is not hot because it
operated only for a short time
or the sensor is damaged.
Power management oper-
ates.
The cookware is too large or
you put it too near to the con-
trols.
Child Safety Device or Lock
operates.
There is no cookware on the
zone.
The cookware is unsuitable.
The diameter of the bottom of
the cookware is too small for
the zone.
There is an error in the hob.
Remedy
Activate the hob again and set
the heat setting in less than 10
seconds.
Touch only one sensor field.
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
Refer to "Daily use".
Put large cookware on the rear
zones, if possible.
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware. Refer to
"Hints and tips".
Use cookware with correct di-
mensions. Refer to "Technical
data".
Deactivate the hob and activate
it again after 30 seconds. If
comes on again, disconnect the
hob from the electrical supply.
After 30 seconds, connect the
hob again. If the problem con-
tinues, speak to an Authorised
Service Centre.
17

Publicité

Chapitres

Table des Matières
loading

Table des Matières