Moving And Braking; Moving And Braking (Movita, Movita 2-S, Movita 2-Xs) - wissner-bosserhoff movita Notice D'utilisation

11. Moving and braking

The bed can be moved and therefore the easy positioning within the room ensures easy clean-
ing of the bed and the space underneath. However, the nursing bed is not suitable for the
transport of residents. The bed may only be moved in its lowest position and without a resi-
dent. Moving the nursing bed to other rooms with a resident still in it does not comply with the
intended use.
Attention!
Injuries could be caused if feet or other body parts get caught in the moving castors
or the undercarriage cladding when moving the bed. When moving the bed, make
sure that your foot does not get caught under the moving castors or under the un-
dercarriage cladding.
Attention!
A bed without the brakes engaged can pose a risk of falling. Always engage the
bed's brakes before leaving. If the resident is unsupervised, move the bed to the
low position.
Please note!
Running over power cables can damage them. Never run over power cables or other
cables.
Please note!
The side panels' anchoring could come loose under high load. To move the bed,
always push or pull it at the head or foot section only.
Please note!
The bed can only be moved if the brakes are released correctly. If still braked
castors are moved across the floor contrary to the instructions, this can result in
damage to the flooring and braking system.

11.1 Moving and braking (movita, movita 2-s, movita 2-xs)

To activate the brake bar, move the bed into the bed egress position or higher. The brake bar
can now be activated with the foot in three positions.
Position 01: Brake
Position 02: Can be moved
Position 03: Direction locking
(In this case, the tilting movement of the left
castor at the head end is blocked, thereby
making it easier to maneuver the bed.)
03
02
01
93