Operation Instructions; Installation Instructions; Electric Shock Hazard; Tools Needed For Installation - Danby DAC150BBCWDB Guide D'utilisation Et D'entretien

OPERATING INSTRUCTIONS
CHANGING THE BATTERY ON THE REMOTE
B

INSTALLATION INSTRUCTIONS

ELECTRIC SHOCK HAZARD

To avoid the possibility of personal injury, disconnect power to the unit before installing or servicing.
NOTE: Your Room Air Conditioner is designed for easy installation in a single or double-hung window.
This unit is NOT designed for vertical (slider type) windows and/or through-the-wall applications.

TOOLS NEEDED FOR INSTALLATION:

• Screwdrivers: Phillips and fl at head.
• Power Drill: 1/8in. (3.2mm) diameter drill bit
• Pencil
• Measuring Tape
• Scissors
• Carpenter's Level
The remote controller is powered by one button cell housed in the
rear part and protected by a cover. Remove the button cell accord-
ing to the arrow marked at the back of the remote controller.
1. Slightly press "A" position according to the number 1 arrow
2. Press "B" position and pull it according to the number 2 arrow
3. The above step 1 and 2 should be done simultaneously to
A
direction by your forefi nger.
direction by your thumb.
slide the button cell out.
11