Operation Instructions; Important - Danby DAC050MB1GB Guide D'utilisation Et Soins De Propriètaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating Instructions
CONTROLS
SELECTOR SWITCH: The selector switch controls fan speed and/or cool-
ing speed. To set desired cooling temperature, simply rotate the
SELECTOR knob to the appropriate setting.
FAN SPEEDS:
• LOW FAN
will circulate air at minimum speed without cooling.
• HIGH FAN
will circulate air at maximum speed without cooling.
COOLING MODES:
• LOW COOL
provides cooling with minimum air circulation.
Recommended for night-time use.
• HIGH COOL
provides cooling with maximum air circulation.
Recommended for quick cooling or for extremely hot days. Once room is
cooled, reduce setting to LOW COOL.
• OFF shuts-down the unit completely
NOTE: Always allow 3 minutes before switching from one mode to
another.
THERMOSTAT: The thermostat automatically controls the (compressor)
cooling cycle and maintains the selected room temperature. To set the
thermostat, rotate the thermostat knob to the desired cooling setting (1
warmest - 7 coldest). The fan motor will continue to operate after the com-
pressor (cooling) has cycled off. This is normal.
When using FAN control, turn selector switch slowly, allowing unit
to adjust. When using THERMOSTAT, be sure to allow three min-
utes before changing temperature. Adjusting too quickly may cause
compressor to overload.
8

IMPORTANT

Thermostat
Selector
OFF
Switch
arrêt

Publicité

Table des Matières
loading

Table des Matières