Danby DAC150BBCWDB Guide D'utilisation Et D'entretien page 16

INSTALLATION INSTRUCTIONS
WINDOW MOUNTING
Remove Chassis:
1
1. Pull down front panel and remove fi lter (See Fig. A).
2. Lift front panel upwards and place to one side.
3. Locate the four (4) front screws and remove (Fig. B). These screws will be needed to re-install the front later.
4. Pry away the front panel from the cabinet sides as shown in Fig. C.
5. Gently lift front off unit and place to one side (See fi g. D)
6. Remove shipping screw from top of unit and also on the side by the base if installed.
7. Hold the cabinet while pulling on the base handle, and carefully remove the chassis from the cabinet.
8. Add two foam inserts to holes in top of cabinet where shipping screws were removed from (See fi g. E).
9. Your unit may come with internal packaging. This packaging must be removed prior to installing the air
conditioner back into the cabinet.
Fig. B
Fig. D
Fig. A
Fig. C
Foam inserts
Fig. E
14