Danby DAC150BBCWDB Guide D'utilisation Et D'entretien page 19

INSTALLATION INSTRUCTIONS
Install Window Lock and Sash Seal
7
1. Trim sash seal to fi t window width. Insert into space between upper and lower sashes (Fig. M).
2. Attach right angle safety lock as shown in Fig. M.
Install Chassis into Cabinet and Install:
8
1. Lift chassis and carefully slide into cabinet, leaving 6 inches protruding.
2. DO NOT push on controls or coils.
3. Be sure the chassis is fi rmly seated towards rear of cabinet.
4. Installation of front is the reverse of removal, outlined in section 1 ("Remove Chassis")
Installing the Energy Effi cient Foam Insert
• After the unit is installed in the window, measure the width of the side curtain.
• If necessary, cut the foam insert down to the width of the side curtain.
• Slide the foam insert into the side curtain.
• Repeat for the other side. (See below)
NOTE: Apply the supplied weather-stripping where needed (cracks and spaces between the foam insert, window
kit and window frame).
Step 1
Fig.M
1/2" screw
17
Safety Lock
Window
Sash Seal
Step 2 Step 3