Configuring The Led Indicator Settings - Renkforce 1582597 Notice D'emploi

r) Configuring the LED indicator settings
84 + 0 + # = Disable the LED indicator (yellow status LED)
3 2 8 9
*
8 4
0
#
*
84 + 1 + # = Enable the LED indicator (yellow status LED)
3 2 8 9
*
8 4
1
#
*
72
Enter the master code (in this example, the master code is "3289")
to enable programming mode, and then press the * key. The code lock
will beep twice and the yellow LED will stay constant to indicate that
programming mode is enabled.
Enter the memory code "84", and then press the disable code ("0").
Press the # key to confirm your entry.
The code lock will beep twice, indicating that standby flash signals have
been disabled. The yellow LED will flash twice.
Press the * key to exit programming mode. The yellow LED will start to
flash again. The yellow LED will no longer flash when the code lock is in
standby mode.
This setting is useful if users may be disturbed by the flashing LED.
Enter the master code (in this example, the master code is "3289")
to enable programming mode, and then press the * key. The code lock
will beep twice and the yellow LED will stay constant to indicate that
programming mode is enabled.
Enter the memory code "84", and then press the activation code ("1").
Press the # key to confirm your entry.
The code lock will beep twice, indicating that standby flash signals have
been enabled. The yellow LED will flash twice.
Press the * key to exit programming mode. The yellow LED will start to
flash again. The yellow LED will flash when the code lock is in standby
mode.