Publicité
Les langues disponibles
Les langues disponibles
iv) Slide on the insulation until it reaches the rear end of the heating unit.
v) Screw on the round nozzle.
vi) Plug in the sprayer and leave it for 2 or 3 minutes, in order to let the
heating unit warm up. Only unplug the sprayer after the heating unit is
no longer needed.
Optimum spraying
To enable a light chocolate covering, the hotCHOC has been specifically
configured to spray around 2 grams per second of 50% chocolate and 50%
cocoa butter mixture, dependent upon the type and temperature. 500ml
can provide a maximum light coverage of 10 - 15 m
coating. A light coverage can be achieved with one pass, using a surface
pattern of about 10 cm, sprayed approx. 30 cm away from the surface.
• Before starting, turn the power knob completely to the left. This is the
maximum power setting and after a few seconds it will allow sufficient
suction for spraying the material. Adjust the power knob as required
until the sprayer demonstrates a fine spray and makes an even tone.
• Maintain a constant distance and smooth movement.
• Avoid shaking the gun or sharp movements as this will cause droplets.
• Varying the speed of arm movement, the height and number of
coatings, will vary the effect and thickness of sprayed material.
• It is recommended to start and stop the sideways movement off the
product and only press the power button when over the product. This
helps reduce the volume being sprayer at the turning point.
• The R6 is the best nozzle for working with chocolate using the
hotCHOC.
• If you want to spray from below, you may rotate the nozzle extension
- however - only rotate in a clockwise direction (when viewed from
the front), otherwise you will loosen the nozzle extension. The easiest
method of adjusting the nozzle direction is from the right side, hold
the pump housing firmly with your left hand and move the nozzle
extension with your right hand.
Spraying other materials?
The sprayer is only designed to spray chocolate. Spraying other low
viscosity (thin) materials (e.g. oil and light glaze) is likely to produce a
different effect.
6
or 5 - 8 m
of thicker
2
2
Publicité
