Troubleshooting - AEG S73320KDW0 Notice D'utilisation

18 www.aeg.com
5.4 Periods of non-operation
When the appliance is not in use for long
periods, take the following precautions:
1. Disconnect the appliance from
electricity supply.

6. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
6.1 What to do if...
Problem
The appliance is noisy.
Audible or visual alarm is
on.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the COOLMATIC,
or after changing the tem-
perature.
2. Remove all food.
3. Clean the appliance and all
4. Leave the door/doors open to
Possible cause
The appliance is not sup-
ported properly.
The cabinet has been re-
cently switched on or the
temperature is still too
high.
The temperature in the ap-
pliance is too high.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The COOLMATIC function
is switched on.
This is normal, no error has
occurred.
accessories.
prevent unpleasant smells.
Solution
Check if the appliance stands
stable.
Refer to "Door Open
Alarm"or "High Temperature
Alarm".
Refer to "Door Open
Alarm"or "High Temperature
Alarm".
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "COOLMATIC func-
tion".
The compressor starts after a
period of time.