Black & Decker CUA625BH Traduction Des Instructions Initiales page 9

Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/battery must be
u
placed in a well ventilated area when
charging.
Electrical safety
Symbols on the charger
Read all of this manual carefully before using the
#
appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
$ corresponds to the voltage on the rating plate.
The charging base is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code
Read all of this manual carefully before
using the appliance
Only use with charger S013C-33-40
S013C-33-40
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Handle
2a. Carrying strap
3. Handle / wand
3a. Flexible tube port
3b. Tube extension latch
4. Extendable crevice tool
5. Hand held vac
(Original instructions)
5a. Dust bowl
6. Dust bowl lid
7. Charging base
7a. Accessory holder
8. Dust bowl lid hinge
9. Hose connector
10. Flexible hose
11. Handle / wand release button
12. Chassis
12a. Light
13. Chassis hose port
14. Floor head
15. 3-in-1 Accesssory tool
16. Pet crevice tool (CUA625BHP only)
17. Long brush tool (CUA625BHA only)
22a. Scent disc (CUA625BHP only)
Use
Switching on and off (Fig. A)
To switch on, press the on/off switch (1).
u
Unit starts in mid performance setting. Performance can
u
be adjusted using power control slider (J2) Left = min
Right = max (as seen when in use from above).
To switch off, press the on/off switch (1).
u
Note: Use the unit in high speed mode with beater bar
switched on for carpet. Use the unit in low speed mode with
beater bar switched off for hard wood and laminate flooring.
Note: The unit has an intuitve 'standby' mode that allows it
to remember the last settings applied for a few minutes upon
starting up.
Note: If leaving the appliance when in use, position the upright
unit, in such a way that any inadvertent fall would contact a
wall or corner and otherwise be away from people and pets.
Control panel (Fig. J)
The unit is equipped with a smarttech control panel providing
Intelligent sensor technology for a more intuitive cleaning
experience.
The features incorporated are:
J1 FLOORSENSOR Touch Button
Intelligent floor sensor technology increases suction on carpets and
switches to Economy Mode for lighter tasks, such as hard floor cleaning,
thus optimising the battery run time this feature is active when the LED
(J1a) is lit. In order to maximise runtime on all surfaces, switch this
feature off by touching area (J1).
J2 Power contol Touch Slider
Touch button panel allows you to control the level of power to the unit
from minimum to maximum by sliding finger along this area.
ENGLISH
9