Télécharger Imprimer la page

hergom L-09 CA Instructions Pour L'installation, L'utilisation Et L'entretien page 32

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40
Do
not
over-adjust
perimeter of the hob. Leave a 10 mm
gap on either side so that it may expand
when hot.
Do not limit the passage of smoke
above the oven, in order to heat the
hob uniformly.
When lighting the cooker for the first
time we recommend a slow fire for 3 to
4 hours. This will allow the cooker to
5.- FIREPLACE LIMITER (Only in L-09 CA model)
This element is used to reduce the
capacity of the hearth and reduce the
water heating capacity, especially in
summer (fig. 16).
INSTALLATION:
In order to install the FIREPLACE
LIMITER,
observe
instructions:
1
Remove the two rings from the hob.
2
Remove the frame (central part of
the hob)
3
Install the side sections "A" on the
grill "G" inside the boiler, with the
internal pins at the rear bottom, as
indicated in fig. 16.
Fig.15
the
external
the
following
expand slowly (stabilise) and avoid any
possible breakages that may take place
if these instructions are not followed.
ATTENTION! It is important to leave a
gap of at least 50 mm between the
cooker and any nearby furniture. Heat
radiation can be limited by protecting
the
areas
near
insulating material, rock wool, ceramic
fibre or similar products
4
Install the rear section "B" on the
grill "G", in front of the pins on the
side sections "A", on which it should
rest. The top part of the rear section
"B" will rest on the boiler tabs "F".
5
Install the front section "C" with the
two pins facing towards the inside
of the boiler, opposite those from
the reach section "B".
6
Install the basket "D" on the pins.
The grill "E" will be placed inside the
basket.
Place the frame and the two rings.
Now, fuel must be loaded through the
top of the cooker (rings).
the
cooker
with

Publicité

loading

Ce manuel est également adapté pour:

L-09 ccL-09 cce