Konect MULTI 60+ Manuel D'utilisation page 8

The beep sounds at every time pressing the buttons to confirm your action. The
beep or melody sounded at various times during operation to alert different mode
changes. These audible sounds can be on or off.
Load Factory Set
Press Enter for 3 seconds to restore factory setting (default).
Enter
This program aims to indicate the current software version number and hardware
Product Version
ID number.
V2.1.5 EADB8902
LITHIUM BATTERY (Li-Ion/Li-Po/Li-Fe/Li-Hv) PROGRAM
These programs are only suitable for charging and discharging Lithium batteries with a nominal voltage of
3.3V, 3.6V, 3.7V and 3.8V per cell. These batteries need to adopt different charge technique is termed
a constant voltage (CV) and constant current (CC) method. The charge current varies according to the
battery capacity and performance. The final voltage of charge process is also very important; it should be
precisely matched with the charade voltage of the battery. They are 4.2V for Li-Po, 4.1V for Li-Ion, 3.6V
for Li-Fe, and 4.35V for Li-Hv. The charge current and nominal voltage as for cell count set on the charge
program must always be correct for the battery to be charged.
When you are willing to alter the parameter value in the program, press Start/Enter key to make it blink
then change the value with INC or DEC key. The value will be stored by pressing Start/Enter key once.
CHARGING LITHIUM BATTERY
The left side of the first line shows the type of battery you select at the users setting. The
LiPo[0] CHARGE
value on the left side of second line sets a charge current and the value on the right side of
2.0A 11.1V(3S)
second line sets the voltage of the battery
After setting the current and voltage press Start/Enter key for more than 3 seconds
to start the process.
(Charge current: 0.1 - 6.0A, Voltage: 2 - 4 S)
This shows the number of cells you set up and the processor detects. "R:" shows
the number of cells found by the charger and "S:" is the number of cells selected by
you at the previous screen. If both numbers are identical you can start charging by
press Start/ Enter button. If not, press Batt type/Stop button to go back to previous
screen. Then carefully check the number of cells of the battery pack to charge again.
The screen shows the present situation during charge process. To stop charging
press Batt type/Stop key once.
CHARGING LITHIUM BATTERY AT BALANCE MODE
This is for balancing the voltages of Lithium batteries of the battery pack to be charged. To do this, the
battery pack being charged should have the individual cell connector. And connect it to the individual port
at the right side of charger with a suitable connection cable that fits with your battery pack. And also, you
need to connect the battery output plug to the output of charger.
8