Kohler K-1111-H2 Mode D'emploi page 6

Operation
NOTE: Please read these steps carefully before operating your whirlpool.
NOTE: The water temperature in the whirlpool should not exceed 104°F (40°C). The heater will
automatically turn off as the water temperature approaches 104°F (40°C) and will remain off until the
water cools.
Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.
Close the drain and fill the bath to a level at least 2" (5.1 cm) above the top of the highest jet.
Place your hand in the bath to test the water temperature for comfort and safety, then carefully
enter the bath.
Press the power icon. The heater will turn on and the whirlpool will start at a medium water flow
volume. Three small lights near the whirlpool floor will illuminate until the keypad goes into sleep
mode.
Press the up or down arrow to increase or decrease the water flow volume. The indicator bar in the
center of the keypad will display the current water flow volume.
Rotate the jet trim clockwise to reduce the air/water flow or counterclockwise to increase the
air/water flow.
Position the Flexjet nozzles to direct the water flow to maximize your hydro-massage experience.
Rotate the outer ring until the heater mode is flashing, then press OK. The heater will turn off. Press
OK again to turn the heater back on.
Press the power icon to turn the whirlpool off. The three small lights near the whirlpool floor will
remain illuminated until the keypad goes into sleep mode.
Repeat the steps above to verify the second keypad is operating properly, less the chromatherapy
functions.
NOTE: The whirlpool will automatically shut off approximately 20 minutes after continuous operation. If
desired, press the power icon to reactivate the whirlpool.
Care and Cleaning
For best results, keep the following in mind when caring for your KOHLER product:
• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and
dry any overspray that lands on nearby surfaces.
• Do not allow cleaners to soak on surfaces.
1042951-5-D
Fill with water 2" (5.1 cm)
above the highest jet.
Turn the Flexjet
trim clockwise to
decrease the flow.
Position the jet nozzles
to direct the water flow
as desired.
Turn the Flexjet trim
counterclockwise to
increase the flow.
6 Kohler Co.