Kohler K-1111-H2 Mode D'emploi page 10

Troubleshooting (cont.)
Symptoms
11. Bath water cools while
pump is operating.
12. Noisy operation.
13. Remote control does not
work.
14. Lights near whirlpool
floor do not work.
Chromatherapy Lights
Symptoms
1. Chromatherapy lights do
not work.
1042951-5-D
Probable Causes
A. Water temperature above 104°F
(40°C).
B. Heater is turned off on user
keypad.
C. Wiring from heater to control is
loose, disconnected, or
damaged.
D. Heater does not work.
E. Control does not work.
A. Pump banding straps have not
been cut.
B. Dry or dislodged jet O-ring
(squeal).
A. Batteries improperly installed or
dead.
B. Antenna on wiring harness is
damaged.
C. Remote control not
programmed correctly.
D. Remote control does not work.
E. Control does not work.
A. Wiring damage.
Probable Causes
A. Loose, disconnected, or
damaged wiring/connections.
B. Control does not work.
Recommended Action
A. Allow bath water to cool.
B. Turn heater on.
C. Check wiring for proper
connections. Refer to the
installer/dealer.
D. Replace heater. Refer to the
installer/dealer.
E. Replace control. Refer to the
installer/dealer.
A. Cut pump banding straps with tin
snips.
B. Remove jet, replace and lubricate
O-ring, and reinstall jet.
A. Replace batteries.
B. Replace wiring harness. Refer to
the installer/dealer.
C. See Homeowners Guide or Service
Manual.
D. Replace remote control.
E. Replace control. Refer to the
installer/dealer.
A. Check for loose or damaged wires.
Repair or replace as needed.
Recommended Action
A. Check wiring for proper
connections. Replace wiring if
necessary. Refer to the
installer/dealer.
B. Replace control. Refer to the
installer/dealer.
10 Kohler Co.