Installation Instructions - NORDIK 15625026 Guide De L'utilisateur

NOTE:
These instructions describe the installation in a typical wood- framed window with a wood SLIDE-BY
sash, or installation in a metal CASEMENT window. Modification may be necessary when installing in windows
made differently than those shown in these instructions.
A high window accessory kit is available for window heights up to 62" (1575 mm). Part # EA103W.
Preparation for installation
Installation tips
For wood-frame casement windows: It may be
necessary to construct a frame, using at least 1"
thick wood, with a 15-1/2" wide opening.
For brick or cement building construction: It may
be necessary to put a wooden strip under the AC, for
mounting purposes.
Tools required (not included)
Flathead screwdriver
Phillips-head screwdriver
Carpenter's level
Measuring tape
Fine-toothed saw
Electric or hand drill
Knife and scissors
Pencil

Installation Instructions

6
WARNING
Failure to adhere to the following precautions could
result in personal injuries and product damage.
Because this unit weighs about 88 to 105 lb,
it is recommended that you have someone help
you when installing your new unit and that you both
use proper lifting techniques. Inspect the condition
of the window where the unit will be installed. Be
sure it will support the weight of the unit.
This appliance must be installed according to all
applicable codes and ordinances.
Handle the AC with care. AVOID touching sharp
metal fins on front and rear coils.
Make sure your AC does not fall during installation.
Do not use water collected in the unit for drinking
purposes. It is not sanitary.